Skip to main content

What is

It's a webhook engine.

It's an open source software that you can deploy on your own infrastructure using Docker. But what does it do? delivers webhooks. Or webhook messages. Or webhook payloads. Whatever you want to call it: it will perform HTTP requests to third party URLs, carrying some payload with it. That's the short version of the story.

However, that is not so simple to do in real life. Read along to know why. is both a software and a website. The website refers to the software. Usually when writing, unless it's linked, it refers to the software, not to the website πŸ™‚

Why would I use this thing?

How do I get started?

First: it's open source, available here.

You can get started by learning how to use, but there are two different scenarios you would want to use it, or two kinds of user who would use it:

  1. People wanting to send webhooks without hassle.
  2. People wanting to receive webhooks from someone that sends webhooks using

Choose the most appropriate section below:

I want to send webhooks

In this case, you can get started by reading the Installation instructions.

But that is just how you get it running. Start at the Sending Webhooks β†’ Quick start page.

I want to receive webhooks

In this case you don't have to install anything. You will be integrating with someone who deployed on their infrastructure.

They will have to provide you with a base URL of where you can access it along with an API token so that you can access the resources to start receiving webhooks from them.

You can get started by jumping straight to the Receiving Webhooks β†’ Quick start page.